Oct 06, 2024 Leave a message

Cutting And Application Of Tantalum Plates, Tantalum Foils And Tantalum Parts

 

The melting point of tantalum is 2980℃, which is second only to tungsten (3380℃) among commonly used refractory metals, and its density is 16.67 g/cm3. In the annealed state, tantalum has good plasticity, is relatively stable at high temperatures, and can absorb and retain gases. Tantalum is acid-resistant and is a biocompatible material. Tantalum is widely used in electronics, chemicals, medical treatment, and cemented carbide production.


Tantalum materials after annealing are soft and tough, and severe adhesion will occur during cutting, causing adhesion and wear of the tool. Especially when the cutting speed is lower than 20m/min, the sticking and tearing phenomena are more serious. When the cutting speed is higher than 40m/min, the tearing phenomenon is greatly reduced. When cutting, the tool is required to be as sharp as possible, and the cutting speed should not be too low. Generally, cemented carbide is used as the tool material, and commonly used ones are YG8, YW2, etc. Use a larger rake angle and main deflection angle, and the tool geometry parameters are: γO=35o~45o, αO=5o~8o, Κr=90o, Κ′r=5o, γO1=-2o~2o, bγ=0.1~0.3mm, rε=0.2~0.5mm, and the surface roughness of the front and back surfaces Ra<0.16~0.32μm to reduce friction and tool sticking.


The selection of cutting parameters is as follows: νc=30~70m/min, ap=5~8mm, f=0.2~0.4mm/r for rough turning; νc=50~80m/min, ap≤1.5mm, f=0.1~0.3mm/r for fine turning and semi-fine turning. Cutting fluid with both cooling and lubricating functions should be used during cutting, and the flow rate should be sufficient.

 

Tantalum plate

 

news-1613-909

 

Tantalum foil

 

news-3264-2448

 

Baoji Yusheng Metal Technology Co., Ltd.

Production scope: tantalum, niobium, vanadium, zirconium, hafnium, etc.

Production products: plates, strips, foils, rods, wires, tubes, particles and other processing profiles, support drawing processing,

Deep processing products: boats, crucibles, grounding rings, bolts, protective tubes, capillary tubes, sputtering targets, coating targets Materials, machined parts, high-temperature furnace heat shields, heating elements, furnace bodies (heating furnaces, annealing furnaces) corrosion-resistant equipment, etc.

CONTACT US? 

  Sales Manager

  Contact: Kelly

Our address

Wenquan village Industrial Zone, Gaoxin Development Zone, Baoji City, Shaanxi Province, China

Phone Number/Facebook

+86 13379388917

E-mail

kd@tantalumysjs.com

news-554-449

 

 

 

 

 

 

Send Inquiry

Home

Phone

E-mail

Inquiry