Condenser Tantalum Tube

Tantalum heat exchanger heats transfer principle: Since the use of heat transfer, that is, the use of non-direct contact heat transfer, also known as condenser tantalum tube, is a heat transfer process achieved by two or more fluids through the intermediate medium for heat transfer.

Tantalum heats exchanger how to select the type?

1. plate type selection plate types or corrugated form should be based on the actual needs of the application of plate tantalum heats exchanger. For the flow of large allowable pressure drop is small, the plate type of small resistance should be selected, and vice versa, choose the plate type of large resistance. According to the fluid pressure and temperature, determine the choice of removable type or braze type. Determine the plate type should not choose a single plate area that is too small plate, so as to avoid an excessive number of plates, the flow rate between the plates is small, and the heat transfer coefficient is too low.

2. the pressure drop calibration in the Kangjing Hui plate tantalum heats exchanger design selection, the pressure drop is also a certain requirement, so it should be calibrated. If the check pressure drop exceeds the allowable pressure drop, the design selection calculation needs to be carried out again until the process requirements are met.

3. the process and flow channels selection process refers to a set of parallel flow channels in the same direction of flow of tantalum heats exchanger media, while the flow channel refers to the tantalum heats exchanger, adjacent to two plates composed of media flow channels. In the plate tantalum heats exchanger selection process, the form of the process combination should be based on heat transfer and fluid resistance calculations, in order to meet the requirements of the process conditions to determine. Try to make the convective heat transfer coefficient in the cold and hot water flow channel equal or close, so as to get a better heat transfer effect.

Tantalum heats exchanger what is the precautions to take?

1. keep the pipe network clean, both before the work of the tantalum heats exchanger, or tantalum heats exchanger work is completed, the pipe network must be cleaned, the purpose of this is to avoid the phenomenon of tantalum heats exchanger blockage. Also pay attention to the timely cleaning of the decontamination device as well as the filter, so that the entire heat exchanged work is completed smoothly.

2. strict control of the softened water, for water quality control, is quite important, in the premise of water quality treatment of softened water, first of all, we must carefully check the water in the system and softening tank waters quality problems, to determine the qualified before the injection process, otherwise, it will affect the normal use of tantalum heats exchanger.

3. new system inspection. For some new systems, that can not immediately alternate with the tantalum heats exchanger, the first need to run the new system in a specified period of time, so that it has a mode of operation, at this time the party can be incorporated into the system to use the tantalum heats exchanger, the purpose of doing so is solely to avoid the impurities in the pipe network to destroy the tantalum heats exchanger equipment. Tantalum heats exchanger because of the effective avoidance of corrosion, so that the service life of the equipment is longer.

As a supplier of condenser tantalum tubes, we can provide you with various specifications of  tantalum tubes, welcome to inquire about it!

Hot Tags: condenser tantalum tube, suppliers, manufacturers, factory, customized, buy, price, quotation, quality, for sale, in stock, Heat Resistance Welded Nb Tube, Tantalum Tube, Tantalum Tube for exchanger, TA0004 Tantalum Tube, Tantalum Tube for Heat Exchanger, Heat Exchanger Tantalum Tube